Hilti TE 60-A36 Originalbetriebsanleitung Seite 31

7 Transport and storage of cordless tools
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 RoHS (Restriction of Hazardous Substances)
Click on the link to go to the table of hazardous substances: qr.hilti.com/r8377057.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
9.1 Troubleshooting
Trouble or fault
No hammering action.
The battery runs down more
quickly than usual.
The battery does not en-
gage with an audible "double
click".
The drive spindle does not
rotate.
Product switches off auto-
matically.
Product switches off if drill bit
jams.
2201898
*2201898*
Printed: 06.06.2018 | Doc-Nr: PUB / 5434377 / 000 / 00
Possible cause
The product is too cold.
Battery condition is not optimal.
The retaining lugs on the battery
are dirty.
The permissible operating temper-
ature of the product's electronics
has been exceeded.
The battery is discharged.
The overload protection system is
active.
The electronic safety shut-down
has tripped to avoid further jam-
ming.
Action to be taken
▶ Bring the product into contact
with the working surface, switch
it on and allow it to idle. If
necessary, repeat the procedure
until the hammering mechanism
begins to operate.
▶ Replace the battery.
▶ Clean the retaining lugs and refit
the battery.
The ON/OFF indicator flashes.
▶ Allow the product to cool down.
▶ Change the battery and charge
the empty battery.
The ON/OFF indicator flashes.
▶ Release the control switch.
Allow the product to cool down.
Press the control switch again.
Reduce the load on the tool.
▶ Release the drill bit.
English 25