Hilti TE 60-A36 Originalbetriebsanleitung Seite 26

3.3 Undercut anchors
The product is suitable for setting undercut anchors. Use only suitable setting tools.
Detailed information on this topic can be obtained at your local Hilti Center.
3.4 ATC
The power tool is equipped with the ATC (Active Torque Control) quick-acting electronic cut-out.
If the accessory tool sticks or stalls, the power tool will suddenly pivot about its own axis in the opposite
direction. ATC detects this sudden pivoting movement of the power tool and switches the tool off immediately.
For ATC to function correctly, the power tool must be free to pivot.
After the power tool has cut out due to ATC, switch it back on again by releasing the control switch
for a moment and then pressing the switch again.
3.5 Active Vibration Reduction
The tool is equipped with an Active Vibration Reduction (AVR) system which reduces vibration noticeably.
3.6 Quick-release chuck (accessory)
The quick-release chuck makes changing accessory tools a quick operation with no additional tools needed.
It is suitable for accessory tools with a cylindrical or hexagonal shank, such as drill bits for wood and metal,
or mixing paddles, operated in "With hammer action"
3.7 Service indicator
The product is equipped with a service indicator LED.
3.7.1 MMI
Status
The Service indicator lights up.
The Service indicator flashes.
The ON/OFF indicator lights up.
The ON/OFF indicator flashes.
The ON/OFF indicator is off.
The Half power indicator lights up.
The Half power indicator is off.
3.7.2 Lithium­ion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Li­ion
battery. The Li­ion battery state of charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
1 LED flashes, the product is not in working order.
4 LEDs flash, the product is not in working order.
Battery state of charge cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
20 English
Printed: 06.06.2018 | Doc-Nr: PUB / 5434377 / 000 / 00
mode.
Meaning
• Servicing is due.
• Have the product repaired by Hilti Service.
• The product is switched on
• The product is switched off because of a
transient fault.
• The product is switched off.
• The product is working at half power.
• The product is working at full power.
Meaning
• State of charge: 75 % to 100 %
• State of charge: 50 % to 75 %
• State of charge: 25 % to 50 %
• State of charge: 10 % to 25 %
• State of charge: < 10 %
• The battery has overheated or is completely
discharged.
• The power tool is overloaded or has overheated.
2201898
*2201898*