Hilti TE 60-A36 Originalbetriebsanleitung Seite 29

2. Push the accessory tool into the chuck as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
◁ The product is ready for use.
4. Pull the chuck ring back as far as it will go and remove the accessory tool.
5.1.6 Inserting the battery
WARNING
Electrical hazard! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts on the
combihammer are free from foreign objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check that the battery is securely
seated in the combihammer.
1. Push the battery into the battery holder until it engages with an audible click.
2. Check that the battery is seated securely.
5.2 Types of work
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is
engaged in the groove provided on the tool.
Observe the safety instructions and warnings in this documentation and on the product.
5.2.1 Drilling with hammering action (hammer drilling)
1. Set the function selector switch to this symbol:
2. Set the desired power level.
3. Press the drill bit against the work surface.
4. Press the control switch.
◁ The product starts.
5.2.2 Drilling without hammer action
Drilling without hammering action is possible when accessory tools with a special connection end
are used. Accessory tools of this kind are available from Hilti. Alternatively, when the keyless quick-
release chuck is fitted, smooth-shank drill bits for wood or steel, for example, can be used to drill
without hammering.
▶ Set the function selector switch to this symbol:
5.2.3 Mixing
Use the mixing paddle only with the quick-release chuck.
Use the mixing paddle only when the reduced power (50%) setting is active.
1. Insert the quick-release chuck in the power tool's chuck.
2. Fit the mixing paddle into the quick-release chuck.
3. Set the function selector switch to this symbol:
4. Press the power reduction (50%) button.
◁ The product is ready for use.
2201898
*2201898*
Printed: 06.06.2018 | Doc-Nr: PUB / 5434377 / 000 / 00
6
.
.
.
English 23