Connection To The Mains - Nordcap CD290-1004 Betriebsanleitung

Carefully read the Instruction manual! If instructions are not followed, there is a risk
of injury, damage of the appliance and loss of the right to free warranty service. We
recommend to keep the Instruction manual the whole time you have the appliance. When you sell
the appliance pass the Instruction manual to the new owner of the appliance.
W A R N I N G !
– Do not cover the ventilation holes at the top and on the sides of the appliance.
Do not use any mechanical means or electrical devices to hasten the thawing
–
process when cleaning the freezer compartment.
Do not use electrical appliances inside the food storage compartments of the
–
appliance, unless they are of the type recommended by the manufacturer.
If the supply cord is damaged it must be replaced by the manufacturer,
–
manufacturer service agent or a similarly qualified person, in order to avoid a
hazard.
– Disposal of the appliance should be according to national rules.
– Do not damage the appliance refrigeration system. It contains the refrigerant gas
R600a. If the refrigeration system is damaged:
Do not use any open flame.
Immediately ventilate the room.
If the appliance is brought in from the cold (temperature is not higher than +12 °C), you should
wait for two hours before connecting it to the mains.
The appliance should not be connected to the mains until all packing and transport materials
aren't removed.
Once the appliance is unpacked, make sure that it is complete, that the body and the electrical
cord aren't damaged.
It is forbidden to use a technically damaged appliance.

CONNECTION TO THE MAINS

The appliance must be plugged into an earthed electricity supply socket. The
–
earthed electrical socket by which the appliance is connected to the mains should
be in an accessible place.
– IF THE APPLIANCE IS PRODUCED WITH THE SPECIAL SUPPLY CORD IT CAN BE EXCHANGED
ONLY BY THE SAME SPECIAL SUPPLY CORD PROVIDED BY THE MANUFACTURER.
– TO AVOID HAZARDS, DAMAGED POWER SUPPLY CORDS SHOULD ONLY BE REPLACED BY THE
MANUFACTURER, A MAINTENANCE TECHNICIAN OR A PERSON WITH AN EQUIVALENT
QUALIFICATION.
DO NOT USE extension cords or connectors (adapters), or hubs.
–
The frequency and power of the electricity supply must conform to the general data
–
parameters of the appliance as it is shown in the product label.
– When positioning the appliance be careful that the electrical cord isn't squeezed in
order to avoid its damage. Do not store heavy objects such as cooling devices,
furniture or other devices next the appliance in such a way that they could squeeze
and damage the electrical cord. This can cause a short circuit and a fire.
– Make sure that the plug of the electrical cord is not squeezed by the back wall of
the appliance or otherwise damaged. A damaged plug can be the cause of a fire!
G B
S A F E T Y I N S T RU C T I O N S
4
devices or lighting fixtures.