Nordcap CD290-1004 Betriebsanleitung Seite 9

D E S C RI P T I O N O F T H E A P P L I A N C E , B A S I C P A RT S ( s e e f i g . 1 )
1 Switch -(ON/OFF);
2
Thermostat knob
3
Thermostat indicator
4
Electricity supply indicator
5 Interior light block (LED)
RE V I E W O F M E C H A N I C A L C O N T RO L ( s e e f i g . 1 )
1 On / off switch for interior light. On / off switch for interior light I -(ON) O –(OFF)
2 Thermostat knob. The thermostat is off when there is a zero (0) in the thermostat indicator
space. Turning the thermostat knob clockwise the temperature in the compartment lowers.
3 Thermostat indicator. Marked with the symbol
4 Electricity supply indicator, marked with the symbol
When the appliance is connected to the electricity supply, the green indicator light is
illuminated. W A R N I N G ! The fan switches on and continuously operates.
P R E P A R I N G T H E A P P L I A N C E F O R O P E RA T I O N
It is recommended to prepare the appliance for operation with a helper.
Remove package. Lift the appliance away from foamed polystyrene base.
If your appliance is fit with screwed handles. Do not rise or push it taking by
handles. Handles may break.
Therefore take out adhesive tapes from sides and simply lift the appliance up and take out
the board. Strip adhesive tapes off and open the door. Remove the spacer above the door.
When positioning the appliance in chosen location, it will move more easily into position if you
lift the front a little and incline it backward allowing it to roll on its casters.
Suitably dispose the packaging material.
Take two supports from the bag (see fig. 4) and insert them into the guides at the top back
part of the appliance.
Place the appliance in a dry, well ventilated room.
W A R N I N G ! The appliance should not be operated in an unheated room or porch.
Place the appliance away from heat sources such as kitchen stove/oven, radiators, or
direct sunlight.
W A R N I N G ! T h e a p p l i a n c e m u s t n o t t o u c h a n y p i p e s f o r h e a t i n g ,
g a s o r w a t e r s u p p l y o r a n y o t h e r e l e c t r i c a l d e v i c e s .
Do not cover the ventilation holes at the top of the appliances – it must be a good air circulation
around the appliance. There should be a gap of at least 10 cm between the top of the appliance
body and any furniture that may be above it. If this requirement is not followed, the appliance
consumes more electrical energy and its compressor may overheat.
If the appliance is placed in a corner, a gap of at least 1 cm must be left between the appliance
body and the wall (see fig. 2).
The appliance must stand on a level surface and must not touch the wall. If necessary, regulate
the height of the appliance by adjusting the levelling feet: by turning them clockwise – the front
of the appliance rises, by turning them counter clockwise – it comes down. If the appliance is
tilted slightly backward – the doors will close by themselves.
P O S I T I O N I N G
8
6 Fan
7
Shelf
8
Cleaner
9
Condenser
10 Compressor