Rimage Everest Benutzerhandbuch Seite 27

3. Install the new print ribbon.
a. Remove the new ribbon
from the packaging.
b. Install the supply roll end
of the print ribbon on the
top of the carrier.
c. Insert the large shaft in
the large opening and
press the small shaft into
place.
Note: The ribbon must
come over the tacky
roller.
d. Wrap the ribbon around the
guide rollers.
e. Install the take up roll.
f. Rotate the take up roll so the
ribbon is aligned and lies flat.
Tip: You may need to lift
the ribbon up from the
tacky roller to straighten it.
Note: If you installe
monocolor ribbon,
advance the ribbon so the
ink portion of the ribbon is
adva nced to the take up
roll.
4. Reassemble the printer.
a. Slide the carrier into the printer.
b. Close latch 1.
c. Close the side cover.
5. Power on the printer. The printer is ready.
110632_L
Large
opening
Supply
roll
d a
Pull handle
Maintain the Everest printer
Small Tacky roller
shaft
Guide rollers
Supply roll
Take up roll
21