Operation In The Menu; Calling Up And Ending Functions - Bosch IUI-UEZ-BE1000s Bedienungsanleitung

Operation in the menu

Calling up and ending functions

Description
All functions used to execute the different
tasks are described on the following pages of
these operating instructions.
Procedure
1. Start code mode (see chapter "Code
mode").
If the user code has been entered properly,
the first "Intern. prog." function of the menu
will be displayed.
01: INTERN.PROG.
2. The right key can be used to jump to
the individual functions consecutively.
01: INTERN. PROG.
02: TOTAL RESET
03: INTERN. RESET
04: DISPLAY TEST
05: AREAS
06: ISOLATE ZONES
07: WALKTEST
00:
If no key is pressed for 1 minute, the
standby picture for the menu is displayed.
STOP CODEOPER
3. Call up a function for processing.
A function, e.g. "TOTAL RESET", is called
up by pressing the "ENTER" key.
TOTAL RESET ?
RESET
4. End code mode.
Select the "STOP CODEOPERATION"
function and confirm with the "ENTER" key.
The code mode will be exited once again.
15 : 13 22.11.2005
MENU
- 13 -