Troubleshooting; Appendix; Disposal Of The Appliance; Disposal Of Batteries - Silvercrest SKF 2800 B3 Bedienungsanleitung

Troubleshooting

PROBLEM
The appliance is not
working.
or
The control lamp integrated
into the on/off switch
does not light up.
The appliance has switched
itself off during use and
cannot be switched back
on.
The green control lamp
does not light up.
If the malfunction cannot be corrected with the above suggestions, or if you have determined
that the malfunction may have other causes, please contact our Customer Service.

Appendix

Disposal of the appliance

Never dispose of the appliance in the normal domestic waste.
This product is subject to the provisions of European Directive
2012/19/EU.
Dispose of the appliance via an approved disposal company or your municipal
waste facility. Please observe the currently applicable regulations. Please contact
your waste disposal centre if you are in any doubt.

Disposal of batteries

Used batteries may not be disposed of in household waste.
Consumers are legally obliged to dispose of batteries at a collection point in
their community/city district or at a retail store. The purpose of this obligation is
to ensure that batteries are disposed of in an environmentally congruent manner.
Only dispose of batteries when they are fully discharged.
■ 86 │ GB │ MT
POSSIBLE CAUSE
The appliance is not connected
with a mains power socket.
The appliance is damaged.
The on/off switch has not
been activated.
The heat protection function
has been activated.
The heat protection function
has been activated.
The selected temperature for
the cooking oil/fat has not
been reached.
POSSIBLE
SOLUTIONS
Connect the appliance to
a mains power socket.
Contact Customer Services.
Press the on/off switch
1. Remove the power plug
and allow the appliance
to cool down.
2. Press the reset button
on the control and heat-
ing element .
1. Remove the power plug
and allow the appliance
to cool down.
2. Press the reset button
on the control and heat-
ing element .
Wait a few minutes until the
required temperature has
been reached.
SKF 2800 B3
.