Remote Connections To Zone Amplifiers - Bose FreeSpace IZA series Installations- Und Bedienungsanleitung

Installation
Configuration example #4:
REMOTE 1 and REMOTE 2 can be a volume control user interface accessory (PC 041966). In this
configuration, REMOTE 1 controls the level of output one and REMOTE 2 controls the level for output
two. A/B source selection for both outputs is simultaneously controlled by the front panel switch. This
configuration requires setting the REMOTE 1 CONTROL DIP switch to ZONE 1 and the A/B SELECT DIP
switch to FRONT.
Bose
1 PWR
volume
control
2 VOL
IZA 2120-HZ
Configuration example #5:
REMOTE 1 can be a volume control user interface accessory (PC 041966). In this configuration, REMOTE 1
controls the level of both outputs simultaneously. A/B source selection for both outputs is simultaneously
controlled by the front panel switch. This configuration requires setting the REMOTE 1 CONTROL DIP
switch to ZONE 1+2 and the A/B SELECT DIP switch to FRONT.
Bose
1 PWR
volume
control
2 VOL
IZA 2120-HZ

Remote Connections to Zone Amplifiers

Remote volume control
The zone amplifiers are designed to work with the Bose
(PC 041966). The REMOTE connector on the rear panel of the amplifier is labeled to match the connector
on the user interface. Use the included 2-pin Euroblock. See the Bose volume control user interface
accessory install guide for more details.
Bose
1 PWR
volume
control
2 VOL
28 - Installation Guide
REMOTE 1
REMOTE 1
ZA 2120-LZ/HZ
REMOTE 1
Bose
1 PWR
volume
control
2 VOL
DIP switch settings
DIP switch settings
volume control user interface accessory
®
pro.Bose.com
IZA 2120-HZ
REMOTE 2