Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Placing on a Flat Surface
The amplifier can be placed on a flat, stable surface like a table, counter, or shelf. The rack-mount ears can
be removed and plastic feet (included with the amplifier) can be installed to protect the surface area and
prevent the chassis from sliding.
Note: When installing the amplifier in an office, conference room, or classroom, carefully place it in a way
that minimizes the audible affects of the internal cooling fan of the amplifier. It is recommended to place
the amplifier below ear level, in a corner, with the fan inlet (left side) pointing away from the seating area.
Installing the Feet on the Amplifier
The included feet are comprised of two parts: a foot and a pin.
1.
Place the amplifier upside-down on a flat, level surface on a protective covering to avoid scratching the
top of the chassis.
2. Insert the four feet into the four holes on the bottom of the chassis.
3. Insert a pin into the hole on the foot.
4. Press down on the pin until the foot locks into place. Repeat for all four feet.
Figure 10. Installing the feet into the bottom of the amplifier
Stacking Units
One amplifier can be stacked on top of another when there is limited space available on a table, counter,
or shelf.
Figure 11. Stacking two FreeSpace amplifiers
24 - Installation Guide
pro.Bose.com
Werbung
Inhaltsverzeichnis
