Konfigurationsbefehle - Mobatime LTS Bedienungsanleitung

2.3.2
Das Gerät kann mit dem Shellbefehl ltsconfig konfiguriert werden.
Die vorhandenen Parameter und Optionen sind unten aufgeführt:
# ltsconfig -H
Usage: ltsconfig 1.04, Copyright Mobatime
[-d yes|no] [-i ip] [-g ip] [-n ip] [-s ip] [-c mode]
[-h hostname] [-o domainname]
[-Lo mode] [-As xxxx] [-Ac xxxx] [-Ai]
[-Om mode] [-Os tbl-entry]
[-Te (0-15)] [-Td] [-Tc] [-Tt xx (1-48h)]
[-To offset (ms)] [-Ts time zone (UTC/CET)]
[-Tn? addr interval (?=1-4)] [-Tne] [-Tnd]
[-Tm? addr ttl interval (?=1-4)] [-Tme] [-Tmd]
[-Se] [-Sd] [-Sc] [-Su] [-Sm addr ttl] [-Sp port]
[-Si t1 t2] [-St m1,m3,m4,m7,...] [-Ss m/u/m?/u? (?=1-80)]
Help:
-H : full usage
-Hn : network options usage
-Ht : timebase options usage
-Hs : time zone server options usage
-Ho : output options usage
-Ha : alarm options usage
-v : version infos
# ltsconfig -Hn
Usage: ltsconfig Network Options:
-d : enable DHCP (yes|no)
-h : stores the hostname in eeprom
-o : stores the domainname in eeprom
-i : set IP address (ddd.ddd.ddd.ddd)
-g : set gateway IP address (ddd.ddd.ddd.ddd)
-n : set DNS IP (ddd.ddd.ddd.ddd)
-s : set subnet mask (ddd.ddd.ddd.ddd)
-c : configures the ethernet mode (auto|(<bps>:<duplex>))
auto for either auto-negotiation or
<bps>:<duplex> mode with <bps> is one of "10" or "100" and
<duplex> is "half" or "full"
# ltsconfig -Ht
Usage: ltsconfig Timebase Options:
-Tt : timebase signal timeout [1-48 hour]
-Te : timebase enabled (valid) for NTP
-Td : timebase disabled (invalid) for NTP
-To : additional timebase input offset [+-1000 ms]
-Ts : timebase input time zone [UTC,CET]
-Tre: enable timebase reference clock input
-Trd: disable timebase referenc clock input
-Tn?: timebase network input source (NTP server ?=1-4)
-Tn? addr interval (2^x second)
-Tn1 10.100.100.14 64
-Tne: enable timebase network input sources
-Tnd: disable timebase network input sources
-Tm?: timebase network multicast output (?=1-4)
-Tm? addr ttl interval(2^x second)
-Tm2 239.192.54.1 4 64
-Tme: enable timebase network multicast output
-Tmd: disable timebase network multicast output
-Tc : Create timebase Konfiguration (ntp.conf)
# ltsconfig -Ho
Usage: ltsconfig Output Options:
-Om : set synchronisation output mode (1pps,dcf,dcfgen,no)
-Os : set synchronisation output time zone (m?,u?)
m?: m=master table, ?=index within this table
u?: m=user table, ?=index within this table
© MOBATIME

Konfigurationsbefehle

10 / 36 800399.04