Interface Cable Connection - Oki DV4360 Bedienungsanleitung

3-2 Interface Cable Connection

Connect the interface cable as shown below.
This printer supports the following communications interface standards.
- RS-232C (Serial)
- IEEE1284 (Parallel)
- USB
USB Cable
1) Turn off the power switch.
2) Connect the communication cable to the printer communication port to be used.
- Connect the RS-232C(Serial) Cable to the SERIAL port.
and tighten the screw on both sides.
This port requires a shielded cable less then 1.8m long.
- Connect the IEEE1284(Parallel) Cable to the PARALLEL port.
and fasten the clips on both sides.
This port requires a shielded cable with ferrite core less then 1.8m long.
- Connect USB cable to the USB port.
This port requires a shielded cable less then 1.8m long.
Rev. 1.0
IEEE1284 (Parallel) Cable
- 13 -
RS-232 (Serial) Cable
LD620D