Direct Currents; A) Iontophoresis; B) Hyperhidrosis - CefarCompex Physio 5 Bedienungsanleitung

5 - Direct Currents

ENG
Never use direct currents on patients
with osteosynthesis devices or other
metal implants.
Iontophoresis and Hyperdrosis
programmes use Direct currents. Do not
use these currents in the chest region.

A) Iontophoresis

Read the chapter "Iontophoresis" in the
practical guide to become fully familiar
with this programme before using it.
NOTE: Use the coloured electrodes
(red, green, yellow) supplied with
the stimulator whenever you use an
Iontophoresis programme.
The Iontophoresis programme is in the
direct current category in the specific
type of treatment.
14a
14a: Press the On/Off button to return to
the previous screen.
14b: Use the channel 1 +/- button to
choose the category you want.
14e: Press the channel 4 +/- button
to confirm your choice and access the
programme selection screen.
15a
15a: Press the On/Off button to return to
the previous screen.
15b: Use the channel 1 +/- button to
choose a programme.
15e: Press the channel 4 +/- button to
confirm your choice.
When working with an Iontophoresis
programme, you can choose the number
of channels and size of electrodes you
want to use. There are 3 electrode sizes
(red, green, and yellow).
You can also edit the default parameters
13
– Duration, Electrical density –
14b 14e
15b 15e
recommended by CefarCompex.
16a 16b 16c
16a: Press the On/Off button to return to
the previous screen.
16b: Use the channel 1 +/- button to
select the parameters you wish to edit:
channel to use, density, and duration
of session. In the above example, only
channel 1 (green electrodes) is active.
The electrical density is 0.05 mA and the
session duration is 6 minutes.
16c: Use the channel 2 +/- button to
choose the electrode size (colour) you
wish to use for each channel and/or
to modify the default values (density,
duration).
16e: Press the channel 4 +/- button
to confirm your choices and access a
confirmation screen.
17a
17a: Press the On/Off button to return to
the previous screen
17e: Use the channel 4 +/- button to
confirm your choices and start the
programme.
NOTE: Current intensity is automatically
calculated according to the size of
electrode used. Electrode size is
determined by colour. Make sure you
choose the correct colour before running
the programme.
Press the i button from the stimulation
screen or the end of programme screen
to access the programme parameters.

B) Hyperhidrosis

Read the chapter "Hyperhidrosis" in the
Practical Guide to become fully familiar
with this programme before using it.
NOTE: The Hyperhidrosis programme
should always be run on channel 1 with
16e
17e