Adjusting The Label Sensor - Weidmuller THM Plus S Bedienungsanleitung

7 Move guides (3) closely to the edges of the mate-
rial without clamping the material.
8 Adjust label sensor.
Please refer to Chapter 4.3 for more infor-
mation.
9 If the printer is equipped with a cutter/perforation
cutter, guide material through the cutter and fold
cutter back to the printing unit.
10 Press printhead down and turn lever (6) clock-
wise to lock the printhead.
1357590000/00/03.12
4.3

Adjusting the Label Sensor

When the printer is delivered the label sen-
sor is positioned in the middle of the paper
feed. Thus, the label sensor must only be
adjusted if:
• material with reflex or cut-out marks,
which are not in the middle,
• multi-strip material with an even number
of strips,
• material with irregularly shaped labels
are used.
3
Fig. 9 Adjusting the Label Sensor
The sensor position (3) is marked with a yellow LED
in the sensor retainer.
1 Press on the knob for adjusting the label sensor
(1) using a pointed object, so that the knob pops
out of the bore of the housing .
2 Position the sensor (3) by turning the knob (1) so
that the sensor can detect the front edge of the
label in the direction of paper flow or the reflex or
cut-out mark.
3 Push knob (1) back into the bore of the housing
using a pointed object until it snaps into place.
Loading Material
1
2
37