Hama TS34A Bedienungsanleitung Seite 7

6. Operation
6.1. Connection to the measuring station
• To connect the base station and the measuring station, place the two
devices as close together as possible.
• After you insert the batteries, the base station automatically searches
for a connection to the measuring station and performs initial setup. If
the device does not connect automatically, the manual search program
on the base station must be started.
Note
• Initial setup takes approximately 3 minutes.
• During the connection attempt, the radio symbol and the LED
indicator (1) on the measuring station will flash.
• Do not press any buttons during setup. Otherwise, values may
not be transmitted correctly and there is a risk of value errors and
inaccuracies.
• The setup process is completed when the indoor and outdoor
measurement data is displayed on the base station.
• The measured value is automatically updated by the base device
about every 57 seconds.
6.2. Selecting the channel/Other measuring stations
Note
• You can connect up to three different base stations to the measuring
station. Ensure that the base station and measuring station are set
to the same channel. Suitable base stations can be found at www.
hama.com
• The transmission channel on the supplied measuring station can be
changed/set (CH1, CH2, CH3).
• The measuring station is suitable for the following base stations:
76045, 113964, 123126, 123127,123128, 123129, 136256, 136257,
136258, 136259, 186306, 186307, 186308; 186353, 186354
6