4. Getting started
• Unscrew the screws on the battery compartment (2) on the back of the
measuring station and open it.
• Move the CH slide switch (4) to the left or right to select the channel
on which the measuring station transmits.
• Insert two AAA batteries with the correct polarity.
• Then close the battery compartment cover.
Replacing the batteries
• Open the battery compartment (2), remove and properly dispose of
the dead batteries and insert two new AAA batteries with the correct
polarity. Then close the battery compartment cover.
Note
Before use, make sure that you insert the batteries in the measuring
station first and then in the base station.
5. Installation
Note – Installation
• We recommend initially placing the base and measuring stations in
the intended locations without installing them and making all the
settings described in 6. Operation.
• Only install the stations once the appropriate settings have been
made and a stable wireless connection is established.
Note – Installation
• We recommend initially placing the base and measuring stations in
the intended locations without installing them and making all the
settings described in 6. Operation.
• Only install the stations once the appropriate settings have been
made and a stable wireless connection is established.
4
a