Maintenance - Makita BST110 Bedienungsanleitung

again and the staples can be fired.
Using the stapler continuously with the head of
•
driven staples remaining above the surface of
material to be fastened may cause damage to the
driver of the stapler and stapler jamming etc..
Checking remaining staples
Fig.12
Remaining staples can be checked through the
finestella.
New staples can be loaded when the pusher is seen in
the center of the finestella.
Removing jammed staples
WARNING:
Always make sure that the lever and trigger are
•
released and the battery cartridge is removed
before removing jammed staples .
Remove the battery cartridge from the stapler.
Fig.13
Press the locking lever on the rear of the sub magazine
and slide the sub magazine backward.
Take out stuck staples that remain inside the opening
that staples are fired from as it appears.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
To maintain product SAFETY and RELIABILITY,
•
repairs, any other maintenance or adjustment
should be performed by Makita Authorized Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Staples
•
Various type of Makita genuine batteries and
•
chargers
Safety goggles
•
or attachments
Only use accessory or
are
6