Specifications; Additional Safety Rules For Tool - Makita BST110 Bedienungsanleitung

ENGLISH
1-1. Red part
1-2. Button
1-3. Battery cartridge
2-1. Trigger
2-2. Lever
4-1. Lever
5-1. Trigger
6-1. Sub magazine

SPECIFICATIONS

Applicable staples length
Staple magazine capacity
Dimentions (L x W x H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for pressing staples into
construction materials such as timbers.
For European countries only
Noise and Vibration
The typical A-weighted sound pressure level is 73 dB (A).
The noise level under working may exceed 85 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to EN792.
EC-DECLARATION OF CONFORMITY
Model; BST110
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014
Directives, 2004/108/EC, 98/37/EC.
000230
Tomoyasu Kato
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Explanation of general view
6-2. Locking lever
6-3. Press
7-1. Main magazine
7-2. Staples
9-1. Groove
9-2. Hook
9-3. Screw
10-1. Trigger
Model
Staple width
Net weight
Rated voltage
2
.
in accordance with Council
CE2007
Director
ENE054-1
ADDITIONAL SAFETY RULES
FOR TOOL
ENG043-1
1. Always wear safety goggles or safety glasses
with side shield, and a full face shield when
needed.
2. Do not point the ejection port at anyone in the
vicinity (especially his face). Keep hands and
feet away from the ejection port area.
3. Always remove the battery cartridge before
loading the staples, adjustment, inspection,
ENH102-7
maintenance or after operation is over.
4. Make sure no one is nearby before operation.
Never attempt to drive staples from both the
inside and outside of wall at the same time.
Staples may rip through and/or fly off,
presenting a grave danger.
5. Watch your footing and maintain your balance
with the tool. Make sure there is no one below
when working in high locations.
6. Check walls, ceilings, floors, roofing and the
like carefully to avoid possible electrical shock,
gas leakage, explosions, etc. caused by
stapling into live wires, conduits or gas pipes.
7. Use only staples specified in this manual. The
use
malfunction of the tool.
8. Do not tamper with the tool or attempt to use it
for other than driving staples.
9. Do not operate the tool without staples. It
shortens the service life of the tool.
10. Stop driving operations immediately if you
3
10-2. Material
12-1. finestella
12-2. Pusher
12-3. Staples
13-1. Sub magazine
13-2. Locking lever
13-3. Press
BST110
10 mm
7 mm - 10 mm
125 pcs
245 mm x 79 mm x 191 mm
1.9 kg
D.C. 14.4V
of any other staples
ENB069-1
may cause