Minutes For Your Safety; Intended Use; Explanation Of Terms; Safety Notices - hanseatic BCD 310CA2W Gebrauchsanleitung

Seite GB-4

5 minutes for your safety ...

5 minutes for your safety ...

Intended use

This appliance is suitable for chilling
fresh food, storing commercially frozen
food, freezing fresh, room-temperature
foods and making ice.
The appliance is intended solely for use
in private households.
Use the appliance exclusively as de-
scribed in this user manual. Any other
use is deemed improper and may result
in damage to property or even personal
injury. The manufacturer accepts no li-
ability for damage caused by improper
use.

Explanation of terms

The following symbols can be found in
this user manual.
WARNING
This symbol indicates a hazard with a
medium level of risk which, if not avoid-
ed, could result in death or serious injury.
CAUTION
This symbol indicates a hazard with a
low level of risk which, if not avoided,
could result in minor or moderate injury.
NOTICE
This symbol warns against possible
damage to property.
This symbol refers to useful supple-
mentary information.

Safety notices

In this chapter you will fi nd general safe-
ty notices which you must always ob-
serve for your own protection and that
of third parties. Please also observe the
warning notices in the individual chap-
ters on operation, setup etc.
WARNING
Risks in handling household
electrical appliances
Risk of electric shock!
Touching live parts may result in severe
injury or death.
Only use the appliance indoors. Do
■
not use in wet rooms or in the rain.
Do not operate or continue to oper-
■
ate the appliance, if
it shows visible signs of damage,
–
e.g. the power cord is defective,
it starts smoking or there is a smell
–
of burning,
it makes unfamiliar noises.
–
In such cases, pull out the mains
plug or unscrew/isolate the fuse and
contact our service department (see
page GB-27).
The appliance corresponds to protec-
■
tion class I and may only be connect-
ed to a plug with a protective conduc-
tor that has been properly installed.
When connecting, make sure that it
has the right voltage. You can fi nd
more detailed information about this
on the nameplate.
Do not connect to a timer or a sepa-
■
rate remote-controlled system for dis-
tance monitoring and control.