HP LineJet Serie Installationsanleitungen Seite 57

Step Key
14.
ENTER
15.
+
16.
CLEAR
17. Examine the print quality. The characters should be fully formed and of uniform
density. If the test does not run or characters appear malformed, check the forms
thickness lever. It should be set to the form in use (A = single-part; B = three-part; C =
six-part). Check the ribbon. It should not be twisted, and it should be tracking correctly.
If there is nothing wrong with the forms thickness lever or the ribbon, contact your
Hewlett-Packard Customer Service Engineer.
18. If the print quality is good, close the printer cover; set the top-of-form, then press
ON LINE to enable printing. To select an emulation and configure the printer with the
control panel, refer to the LineJet Series Printers: User's Guide .
Result
Printer Tests
Shift Recycle*
ENTER SWITCH
LOCKED
OFFLINE
CONFIG. CONTROL
Section 8: Testing the Printer
Notes
Stops the test.
Locks the ENTER key.
57