HP LineJet Serie Installationsanleitungen Seite 32

English
4
I/O Connector Cover
Connect the (customer-supplied) interface
cable from the host computer to the
appropriate printer interface connector. Refer
to Chapter 4, "Interfaces", in the LineJet
Printers: User's Guide for descriptions of the
connectors and their pin assignments.
Use of shielded cables is
Note
required to comply with
government RFI regulations.
Open the cabinet rear door, and remove the
cover from the I/O connector you have
selected.
32
Parallel Connector
Serial Connector
Connect the I/O connector to the printer
connector. Secure the connector with the two
wire connector clips (Centronics). Route the
cable down and into the plastic cable
standoffs.
Push the I/O cable into the rubber grommet at
the lower left rear of the cabinet.
5
Rubber
Grommet