Kirami CUBE Gebrauchsanweisung Seite 17

CUBE outside hot tub heater- Instruction manual
Installation for Original Woody tubs
Kirami wooden tubs have Ø75mm connection pipe pieces and
preinstalled holes with bolts and nuts to fix the connection plates
delivered with the tub.
1) Install the delivered plates and leave them loose, it makes the
insertion of the heater easier.
2) The heater is pushed into its place so that the tub pipes go
inside the hoses on the heater. And the heater remains in
horizontal position.
3) Tighten the hose clamps form both ends. And the tub
The heater will be hanging on the wall of the tub by the hoses ad plates
Installation for Comfort Cozy tubs
Cozy hot tubs do not have connection plates. So the heater is
connected just with the hoses and clamps just like Woody installation
points 2) and 3). If you have purchased a Cube drink holder or version
of the hot tub with covering side plates those can be attached with
included screws to the heater plates. With Cozy hot tubs the heater
must have some supports underneath so that it will not hang from the
hoses.
Installation further away from the tub
The standard heater should not be installed further away from the tub. If you are planning
installation further away from the tub then you should purchase a special version with extra
emptying valve + air release valve on top. And also separately ordered pipes between the
heater and the tub and an extra set of fixing hoses and clamps. When installing further away
the heater must be a bit lower than the tub so that the natural circulation of heated water
works. Remember to install the emptying valve and air release valve on the heater in this
case. Also build a support for the heater when it is not fixed on the tub. And remember to
empty the heater from its own valve after use.
plates.
4) Use the supplier self drilling
screws to fix the heater to
the tub's plates. The screws
are meant to drill through
the wooden panel, the tub
plates and the
plates. There should be three screws on each side of the
heater. Four top ones make the actual fixing and the two
lower ones fix the panel so that it stays in nice vertical
position. If a drink holder / panels is not installed the only
two screws are used on both sides.
heater
EN
Page 17/52
Updated 08/2013