English - LuxaFlex Twist Montageanleitung

English

TIP BEFORE YOU START!
Position the installation brackets so that the Luxaflex® Twist™ Roller Blind does not
come into any contact with any protruding parts such as window/door handles, window sills, etc.
FIXING THE INSTALLATION BRACKETS
1. Wall mounting
Fix the brackets to the wall (1a and 1b). The position of the first and last bracket needs to be 60mm
from the end (1c). For wider blinds three brackets need to be used. Make sure the third bracket is in
the centre of the blind. Fix the bracket position to assure level mounting of the blind horizontally.
2. Ceiling mounting
Fix the adjustable brackets to the ceiling (2). The position of the first and last clip needs to be 60mm
from the end (1c). For wider blinds three brackets need to be used. Make sure the third bracket is
in the centre of the blind. Adjust the brackets to assure level mounting of the blind horizontally.
FITTING TWIST™ ROLLER BLIND
3. Blind installation
Tilt the blind in an about 10° position. Place the bottom side of the mounting profile on the bottom
side of the clip (3a). Press the mounting profile against the clip until it clicks (3b).
4. Adjusting the blind
If the fabric does not roll up straight, place the supplied hex key in the screw of the leveller on the
non-operation side of the roller blind. Turn the key left or right to adjust the tube position in the
bracket up or down (4). Support heavy blinds by lifting tube manually with the palm of your hand
and adjust the leveler position while supporting.
OPTION
5. Removable crank
To prevent unauthorized operation of the blind, the crank wand can be easily detached from the
system and kept out of reach.
• To remove the wand: lift and rotate the wand for quick-release from the system.
• T o reattach the wand: aim with the funnel on top of the wand towards the operation system. Lift
and rotate the wand for locking on the system (5).
DISMANTLING
6. Removing the Twist™ Roller Blind
Place a flat screwdriver between the clip and the mounting profile and turn it 45°. Remove the
blind of the clip.
4
CLEANING ADVICE
Gently clean the fabric with a brush or a dry towel.
WARNING
• Y oung children can be strangled by loops
in pull cords, chains, tapes and inner cords
that operate the product. They can also wrap
cords around their necks.
• T o avoid strangulation and entanglement,
keep cords out of reach of young children.
• M ove beds, cots and furniture away from window covering
cords.
• D o not tie cords together. Make sure cords do not twist and create
a loop.
• I nstall and use the included safety devices according to the
installation instructions on these devices to reduce possibility of
such an accident.
According to EN 13120:2009+A1:2014.
LIABILITY
The above advice has been carefully put together. The manufacturer accepts no liability whatsoever
if the installation and/or operating instructions have not been followed or have been followed
incorrectly. We can accept no responsibility for the results of treatments. Barring amendments and
product improvements.