Safety Advice; Before First Use; Getting Started - Electrolux ESM33 series Gebrauchsanweisung

BG

SAFETY ADVICE

Read the following instruction carefully before using machine for the first
CZ
time.
DE
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience
DK
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
EE
• Children should be supervised to ensure that they do not play with the
ES
appliance.
• Never use or pick up the appliance if
FI
– the supply cord is damaged,
– the housing is damaged.
FR
• If the appliance or the supply cord is damaged, it must be replaced by the
GB
manufacturer, its service agent or similarly qualified person, in order to avoid
hazard.
GR
• Always disconnect the appliance from the supply if it is left unattended and
before assembling, disassembling or cleaning.
HR
• Care shall be taken when handling the tools, emptying the bowl and during
HU
cleaning.
• Switch off the appliance and disconnect from supply before changing
IT
accessories or approaching parts that move in use.
• Do not immerse the appliance in water or any other liquid.
LT
• When processing heavy load, do not use the appliance continuously for
LV
more than 30 seconds. Allow to cool down before restarting.
• This appliance is intended for domestic use only. The manufacturer cannot
NL
accept any liability for possible damage caused by improper or incorrect
use.
NO

BEFORE FIRST USE

PL
1. Before using your appliance, remove all packing material, plastic, labels, stickers or tags that may be
PT
attached to the motor base, bowls or attachments.
Warning! Never immerse the housing, plug, or cord in water or any other fluid.
RO
Caution! Switch off the appliance and disconnect from supply before changing accessories or
approaching parts that move in use.
RS
2. Wash all parts, except for the motor base, in warm soapy water. Dry each part thoroughly before use.
RU
Whisks and dough hooks can be cleaned with a brush under running water or in the dishwasher.
3. The housing should only be cleaned with a soft damp cloth, then dried with a cloth.
SE Note: Do not use abrasive cleansers or scouring pads to clean the surfaces of your appliance.

GETTING STARTED

SI
4. Fitting the mixer to the processor stand. Before fitting or removing the mixer, switch off the mixer (by
moving the speed selector all the way to the left) and remove the plug from the mains
SK
push the mixer on to the processor stand and press down to lock.
5. Removing the mixer from the processor stand. To remove, press the lock release and pull the mixer
TR
upwards.
6. Raising/lowering the mixer. Ensure that the mixer is switched off before raising/lowering! Press the
UA
raise/lower button and swing the mixer up or down, until it clicks in place.
www.electrolux.com
Mattino_StandMixer_Electrolux_2.indd 28
socket. To fit,
28
2016-05-11 08:04:22