Before Starting Operation; Setting Up Power Supply - Bresser ClimaTemp FW Schnellstartanleitung

19 Symbol for RCC signal
21 Symbol for active alarm

9 Before starting operation

NOTICE
Avoid connectivity disruptions!
To avoid connectivity disruptions between the devices, consider the following points before starting
operation.
1. Place base station (receiver) and remote sensor (sender) together as close as possible.
2. Set up power supply for the base station and wait approx. 5 seconds.
3. Set up power supply for the remote sensor.
4. Position the base station and the remote sensor within the effective transmission range.
When changing batteries always change all batteries and replace them in the correct order, so the re-
mote connection can be re-established. If either of the devices is mains-powered, the power supply
must be disconnected for a short moment also for this device when exchanging the batteries. If batter-
ies are exchanged in only one of the devices (i.e. the remote sensor) the signal can't be received or
can't be received correctly.
Note, that the effective range is vastly affected by building materials and position of the main and re-
mote units. Due to external influences (various RC devices and other sources of interference), the
maximum distance can be greatly reduced. In such cases we suggest to position the main unit and the
remote sensor at other places. Sometimes all it takes is a relocation of one of these components of a
few inches! Though the remote unit is weather proof, it should be placed away from direct sunlight,
rain or snow.

10 Setting up power supply

Base unit
1. Remove the battery compartment cover.
2. Insert the batteries into the battery compartment. Ensure that the battery polarity (+/-) is correct.
3. Replace the battery compartment cover.
Thermo-Hygrometer
4. Remove the battery compartment cover.
5. Insert the batteries into the battery compartment. Ensure that the battery polarity (+/-) is correct.
6. Replace the battery compartment cover.
NOTICE! The power supply of the wind / rain gauge is ensured via the cable connection to the
thermo-hygrometer. (For more information, see the chapter 'Installing the multisensor set')
20 Current time (seconds) or weekday or
alarm time (display depends on the selec-
ted display mode)
9 / 24