Sanus VMA401 Bedienungsanleitung Seite 6

2 Mount the Wall Plate
Wood stud
2-1 Locate stud
2-2 Mark the wall
2-3 Drill pilot holes
2-4 Tighten lag bolt and screw
6
≤ 16 mm
(5/8 in.)
[01]
[04]
[05]
[01]
Verify the center of the stud using an awl, a thin nail, or an edge to
edge stud finder.
CAUTION:
damage!

Drywall covering the wall must not exceed 16 mm (5/8 in.).

Minimum wood stud size: common 51 x 102 mm (2 x 4 in.)
nominal 38 x 89 mm (1½ x 3½ in.).
IMPORTANT: For stacking configurations, stack from the top down.
Remove the front (F) and top (T) covers from the wall plate [01].
Level the wall plate [01] and mark the hole locations.
(T)
(F)
CAUTION:
holes MUST be drilled to a depth of 63.5 mm
(1/8 in.) diameter drill bit.
Use the lag bolt [04] and washer [06] to secure the top of the wall plate.
Use the #8 screw [05] to secure the bottom of the wall plate.
CAUTION:
lag bolt. To avoid potential injuries or property damage

DO NOT over-tighten the lag bolt [04] or the screw [05].

Tighten the lag bolt [04] only until the washer [06] is pulled firmly
[06]
against the wall plate [01].
11 mm
(7/16 in.)
Avoid potential personal injuries and property
[01]
Avoid potential injuries or property damage! Pilot
63.5 mm
(2½ in.)
Improper use could reduce the holding power of the
3 mm
(1/8 in.)
(2½ in.) using a 3 mm
6901-002141 05