Inhaltsverzeichnis
Werbung
ELZI
30, 40, 60
6. Life Stages
6.2.4 Installation of Coupling and Motor
There are two methods to install the motor, either without gears or with a planetary gear.
The manufacturing tolerance are very low, therefore we recommend buying the adapter directly from Bahr Modultechnik.
Angular misalignments and misalignments with respect to the centre of the adapter can lead to serious damages at the
coupling and the bearings.
Another source of defect is the possibility that the coupling knobs might hit each other. Before installing the motor, the safety
distances of 1 mm must be checked.
Installation of coupling and motor - pivot variant with/without feather key
- Clean the pivot and coupling clamping area using solvent
- If necessary, slightly push the coupling hub apart with the help of a screw driver
- Push the coupling onto the pivot with the whole hub length and tighten with the permitted
torques
- Check the safety distances of the coupling knobs (min. 1 mm).
- Push the motor into the adapter and fix it
1,0 mm
1,0 mm
Montageanleitung / Maschinenrichtlinie
Installation Instructions
24.09.2012
Seite / Page 15
Werbung
Inhaltsverzeichnis
