Inhaltsverzeichnis
Werbung
ELZI
30, 40, 60
6. Life Stages
6.2 General
- Before installation, the corrosion protection at the shaft ends of the driven linear units must be removed.
- Cleaning agents must be prevented from entering the bearings.
- When installing transmission elements such as couplings or motor adapters, impacts or hits on the shaft ends and
driving journals must be avoided in order to prevent the bearing from being damaged or becoming unbalanced.
- The linear unit must be secured on a level surface with a minimum accuracy of 0.20 mm/m2.
- The linear unit must not be warped during installation.
- When the system is to be operated, sufficient fixing points must be selected between and linear unit and
the mounting surface.
- The loads to be moved by the linear unit must be secured properly and sufficiently for the corresponding
application.
- The high dead weight of the component parts and the linear unit presents hazard for people and property.
- When mounting a motor on the linear unit, ensure that the motor shaft and the drive shaft of the linear unit
are axially aligned.
Montageanleitung / Maschinenrichtlinie
Installation Instructions
24.09.2012
Seite / Page 12
Werbung
Inhaltsverzeichnis
