ELZI
30, 40, 60
6. Life Stages
6.2.3 Coupling/Motor Adapter/Motor
The motor can be installed on the pulley with or without gears.
To ensure that this positioning system does not cause a risk, the drive must be designed correctly.
The design and manufacture of the motor adapter must ensure that no axial, radial or angular misalignment can occur.
The installation of the motor follows a logical sequence.
One coupling half is mounted on the pivot of the positioning system.
The second coupling half is mounted on the drive and pushed through the installed motor adapter on
the positioning system which has been prior equipped with the other coupling half.
Montageanleitung / Maschinenrichtlinie
Installation Instructions
24.09.2012
Seite / Page 14