Inhaltsverzeichnis
Werbung
ELZI
30, 40, 60
6. Life Stages
6.1 Transport and Storage
When transporting the linear units, you must ensure that a crane, lifting truck or even persons do not grip the unit at the
end elements. The load must be sufficiently secured during transport and the centre of gravity must be observed in order to
prevent the load from tilting.
- Never stand or walk under the load. Respective P.P.E.( Personal Protective Equipment)
must be worn during all measures.
- Accident prevention regulations and safety precautions must be observed.
- During transport and storage, impacts or hits on the shaft ends or driving journals must be avoided.
Any damages due to transport or storage must be reported to the responsible person and Bahr Modultechnik GmbH imme-
diately. The product must be checked for any visible and functional defects by qualified personnel. The start-up of damaged
linear units is prohibited.
The following environmental conditions are prescribed for storing the linear unit:
- no oil contaminated air
- contact with solvent-based lacquers must be prevented
- lowest/highest ambient temperature: 0°C/+60°C
- humidity during storage: storage below dew point is inadmissible
- Supporting the complete surface of the profile body or an appropriate number of support points along the length
of the guide profile will prevent the linear unit from deforming.
Any environmental conditions deviating from the requirements described above will have to be approved
by Bahr Modultechnik GmbH.
Montageanleitung / Maschinenrichtlinie
Installation Instructions
24.09.2012
Seite / Page 11
Werbung
Inhaltsverzeichnis
