Extensions; Wet And Dry Applications - Nilfisk-ALTO ATTIX 130 Betriebsanleitung

- Before plugging the vacuum cleaner into the
electricity mains, make sure that the voltage rating
indicated on the data plate corresponds to that of
the electricity mains.
- Plug the vacuum into a socket with a correctly
installed ground contact/connection.
- Make sure that the vacuum cleaner is off.
- The plugs and connectors of the connection cables
must be protected against splashed water.
- Make sure that connections to the electricity main
and plug are correct.
- Only use vacuum cleaners when the cables that con-
nect to the electricity main are in perfect condition
(damaged cables could lead to electric shocks!).
- Regularly check that the electric cable does not
show signs of damage excessive wear, cracks or
ageing.
ATTENTION DANGER !
When the vacuum cleaner is operating, do not:
- crush, pull, damage or tread on the flex that con-
nects to the electricity main;
- only disconnect the flex from the electricity main
by removing the plug (do not pull the flex);
- only replace the electric power cable with one of
the same type as the original: HO7 RN-F. The same
rule applies if an extension is used;
- the flex must be replaced by the manufacturer's
Assistance Service staff or by an equivalent qua-
lified personnel.

- Extensions

If an extension is used, make sure it is fit for the power
draw and protection degree of the vacuum cleaner.
Minimum section of extension cables L = 20 m max -
Cable = HO7 RN - F.
Maximum power
3
(kW)
Minimum section
2,5
(mm )
2
ATTENTION DANGER !
Sockets, plugs, connectors and installation of the
extension cable must maintain the IP protection
degree of the vacuum cleaner, as indicated on the
data plate.
07/2008
5 15 22
4 10 16
ATTENTION DANGER !
The vacuum cleaner's power socket must be protected
by a differential circuit-breaker with surge current
limitation, that shuts off the power supply when the
current dispersed towards ground exceeds 30 mA for
30 msec. or an equivalent protection circuit.
ATTENTION DANGER !
Never spray water on the vacuum cleaner: such action
constitutes a danger hazard for persons and could
short-circuit the power supply.
Consult the latest edition of the European Union
Directives, the Laws in the country of use and the
current standards in force (UNI - CEI - EN), particularly
European standard EN 60335-2-69.

- Wet and dry applications

Note
The supplied filters and the safety container (if applicable)
must be installed correctly.
If the machine is used to clean up liquids, make sure
that the liquid level sensor activates and operates in the
correct way.
ATTENTION DANGER !
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
ATTENTION DANGER !
If the wet cleaner variant is used:
- make sure that the liquid level sensor operates
correctly before using the vacuum cleaner to clean
up liquids;
- if foam forms, immediately stop work and empty
the container.
- Warning: switch off the vacuum cleaner immediately
if foam or liquid leaks out.
- Regularly clean the liquid level limiting device
and check to make sure that there are no signs of
damage.
- Warning: the dirty liquid collected by the vacuum
must be considered conductive.

ATTIX 130
GB
C319