Operating Instructions For The End User - Neptun Compact 950 Montage- Und Betriebsanleitung, Pflegetipps

GSA 950-1200 Edelstahl_Layout 1 a4 14.12.18 08:59 Seite 13

operating instructions for the end user

Turn the pump on/off (see fig. 1)
By pressing the push button pos.1, the pneumatic switch is actuated and the pump is in opera-
tion. Press again to turn off the pump.
stream direction and beam control (see fig. 1)
The stream direction can be set by the all-round swiveling nozzle pos. 2. By rotating the nozzle
you make the water flow more or less.
air control and massage (see fig. 1)
By rotating the ring pos. 3 which is mounted on the nozzle, the air supply gets weaker or stronger.
swimming against the countercurrent
Swivel the nozzle that the water layer directly below the water surface is placed in strong current.
Use of the massage equipment (see fig. 2):
Before installing or removing, the countercurrent system must be switched off. To attach the mas-
sage unit, pull back the sliding sleeve pos. 5 and push the hose coupling in the nozzle pos. 2.
Then press the sliding sleeve against the nozzle and pull the hose back pos.6. The hose coupling
is locked. To uncouple, press the hose pos. 6 against the sliding sleeve pos. 5. Take the sliding
sleeve and pull it out.
Attention:
Do not take the massage equipment closer than 30 cm to your body, you get the optimal mas-
sage effect at full flow capacity and suitable distance.
Wintering
Drain the water to below the nozzle block. The pump must be emptied with the help of the drai-
ning screw on the front oft the pump. Only after the end of the danger of frost the drain plug can
be screwed again.
13
Betriebsanleitung GSA Compact 950/1200 Edelstahl V.20181129