Operation; Kneading And Whisking - Silvercrest SHMS 300 C2 Bedienungsanleitung

Turbo button / :
■ This button allows you to switch the appliance to
full power immediately.
■ This button starts the blender

Operation

Kneading and whisking

ATTENTION! PROPERTY DAMAGE!
► Do not operate the mixer continuously for longer
than 10 minutes. After 10 minutes, take a break
in order to allow the appliance to cool down.
NOTE
► Put the attachments into the food to be beaten/
whisked/kneaded before turning on the
appliance.
Kneading
Whisks
hooks for
for stirring
kneading
batter or cake
heavy doughs,
mixture or
e.g. yeast
for whipping
dough.
cream.
1) Clean the attachments ( ,
use.
■ 20
│ GB│IE
2) Push the whisks
if it is attached.
3) Release the mixer holder on the mixer stand
4) Remove the mixing bowl
ATTENTION! PROPERTY DAMAGE!
►
Blender
for puréeing
fruits/veg-
etables, e.g.
►
apples.
, ) before first
5) Replace the mixing bowl
6) Press the mixer holder release
7) Place the hand element
8) Push the lid
or the kneading hooks
into the slots on the hand element
click audibly and firmly into place.
Always insert the kneading
hook
with the toothed ring on
the shaft into the intended
slot on the appliance, which
is marked with an icon.
Insert the kneading hook
or the whisk
smooth ring on the shaft
only into the intended slot
on the appliance, which is
marked with an icon.
by pressing the mixer holder release
and fold the mixer holder upwards.
ingredients. Quantities depend on the amount
to be prepared.
Never fill the mixing bowl
MAX marking (approx. 2.5 l). Otherwise,
the ingredients will spill over the edge of the
bowl during mixing.
Never add more than 1.5 kg of ingredients
(in total) to the mixing bowl
the motor could be damaged.
stand .
swing the mixer holder back downwards.
so that it firmly clicks into place.
into the rails on the mixer stand
so that it sits firmly in place.
until they
or the whisk
with the
and fill it with the
higher than the
. Otherwise,
on the mixer
and
on the mixer holder
SHMS 300 C2