Operating Elements And Connections; Front Panel; Rear Panel - Omnitronic EQ-25 MK2 Bedienungsanleitung

4 Operating Elements and Connections

Front panel

1
2
OVERLOAD BYPASS
No. Element
1 Mounting brackets
2 Overload indicator
3 Bypass switch with
indicator
4 Tone controls
5 Power switch with
indicator

Rear panel

6
7
No. Element
6 Fuse holder
7 Power input
8 Line inputs
9 Line outputs
3
Function
Delivery includes mounting brackets for 19" (483 mm) rack installation.
Fix the brackets at the left and right side of the housing.
This indicator lights up in case of an overload input signal. If it lights
permanently, reduce the level of the signal source.
This button disables and enables the equalizer section and thus allows
comparing the processed signal with the original unprocessed signal.
When the button is depressed the equalizer settings are disabled and the
LED next to the button lights up as a control.
For boosting and attenuating the respective frequency band level within a
range of ±12 dB. To boost a frequency range, turn the control clockwise;
to attenuate, turn the control counterclockwise. When in center position
(0 dB), the particular frequency range is not processed at all. The bass
range can be used to create a cappella effects. The midrange allows to
cut vocals and melody from the source material and the high range can
be used to emphasize the sound of the cymbals or hi-hats.
• control 75 Hz: bass range
• control 300 Hz: lower midrange
• control 2 kHz: higher midrange
• control 3 kHz: lower high range
• control 10 kHz: higher high range
Turns power to the unit on and off. When powered on, the indicator lights
up.
Function
Only replace the fuse when the device is disconnected from mains. Only
use fuses of the same rating and power. The correct fuse value is
specified on the rear panel.
Use the included power cable to connect this input to a power outlet.
input.
Balanced XLR and unbalanced RCA jacks for connecting the signal
source. Use standard XLR or RCA cables to connect these inputs to
e.g. a mixer or preamplifier.
Balanced XLR and unbalanced RCA jacks for connecting subsequent
units. Use standard XLR or RCA cables to connect these outputs to e.g.
a PA amplifier.
4
8
R
OUTPUT INPUT
9
13 • EN
5 1 1
EQ-25 MK2
DJ EQUALIZER
8
L
OUTPUT INPUT
9
XLR