Operating Instructions; Operating Tips; Technical Service - VWR 1000 Bedienungsanleitung

O I - S
PERATING NSTRUCTIONS
The Standard Orbital Shaker is used for general laboratory shaking needs.
Model 1000
1. Getting ready:
a. The speed knob should be at their extreme counter-clockwise
position or at the #1 on the dial.
b. Make sure the rocker switch is in the stanby position.
c. Plug the cord into a properly grounded outlet.
2. Setting speed:
a. To run push rocker to the on position. Set speed knob to desired set-
ting and adjust if necessary. Unit will run until you move
the rocker switch to the off position. The microprocessor speed
control slowly ramps to set speed to avoid splashing.
3. Turning unit off:
a. To stop shaking function, turn the speed knob to the extreme
counter-clockwise position and push the rocker switch to the standby
position. The shaker should be kept in the standby position when not
in use. To completely cut off power to the unit, disconnect the power
cord from the unit or unplug from the wall outlet.

OPERATING TIPS

Centering your sample and even weight distribution on the tray helps with
balance and stability.
The shaker will automatically restart after a power interruption.
T S
ECHNICAL ERVICE
For information or technical assistance contact your local VWR representa-
tive or visit vwr.com.
O S
TANDARD RBITAL HAKER
4