Operation / Settings - GRAPHITE 58G119 Betriebsanleitung

Two diodes on the charger (10) light up: green and red. Green diode indicates connection of the charger to mains, red
diode indicates the battery is being charged. Depending on battery discharge level, the battery will be charged after 3 to
5 hours.
Do not charge the battery for more than 8 hours. Exceeding this time limit may cause damage to battery cells.
Charger will not turn off automatically when the battery is full. Red diode on the charger will remain lit. Disconnect
power supply before removing the battery from the charger. Avoid consecutive short chargings. Do not charge the
battery after short use of the drill. The battery and the charger heat up during charging. This is normal. Significant
decrease of the period between chargings indicates the battery is used up and should be replaced.
ROTATABLE BATTERY
This function allows for such setting of the battery, so it does not make the operation in hardly accessible places difficult.
The battery can be rotated 360° in horizontal plane (fig. C).
SWITCHING ON / SWITCHING OFF
Switching on – press the switch button (6).
Switching off – release the switch button (6).
ROTATIONAL SPEED CONTROL
Screwing or drilling speed can be controlled during operation by increasing or decreasing pressure on the switch button
(6). Speed control enables soft start, which prevents drill slip when drilling in gypsum or glaze, and helps to control the
operation when screwing and unscrewing.
OVERLOAD CLUTCH
Setting the ring (2) in given position causes permanent setting of the clutch to specified torque. When the set torque is
reached, overload clutch releases automatically. It prevents screwing screws too deep or damaging the drill.
TORQUE CONTROL
● Different screws and materials require different torque to be applied.
● The bigger the number corresponding to given position, the bigger the torque (
● Set the ring ( 2) to specified torque.
● Always start operation with low torque.
● Increase the torque gradually until appropriate value is set.
● Use higher settings to unscrew screws.
● When drilling choose settings marked with the drill symbol. When this setting is set, the torque is the greatest.
● Knowledge how to choose appropriate settings comes with practise.
Setting the ring in the drilling position deactivates the overload clutch.
CHANGE OF GEAR
Drill features gear switch (7) (fig. H), which broadens the range of rotational speed.
Gear I: small speed range, big torque
Gear II: big speed range, low torque
Set the switch in appropriate position depending on the works performed. Turn the spindle slightly if the switch cannot be
moved.
Never change the switch position under operation of the drill. It may damage the power tool.

OPERATION / SETTINGS

15
fig. D).