Useful Advice; Use - De Dietrich DHD7960B Installationsanleitung

1
•
HOW TO INSTALL THE HOOD
In order to ensure the Downdraft pro-
per operation, installation instruc-
tions shall be carefully followed.

Useful Advice:

- Use an air exhausting pipe whose ma-
ximum length does not exceed 5 meters.
- Limit the number of elbows in the pi-
ping, since each elbow reduces the air
capacity of 1 linear meter. (Ex. : if you
use no. 2 x 90 ° elbows, the length of
piping should not exceed 3 meters).
- Use only piping approved by relevant
standards in force.
- Avoid abrupt direction changes.
- Any problem due to failure to com-
ply with aforementioned instructions in
terms of performances and noise level
will not be the supplier's liability and the
appliance will not covered by the manu-
facturer's guarantee.
- Use a 150 mm. constant diameter pipe
or similar section for the whole length.
CAUTION: In order to know the speci-
fic input of the appliance expressed in
WATT, the installer shall tick the box cor-
responding to the type of external motor
installed found in the adhesive label pla-
ced beside the appliance rating label, as
shown in the figure below.
DHD7960B
1) Drill a rectangular hole in the rear side
of the kitchen worktop of the following di-
mensions for 90 cm Downdraft:
794X106mm.
2) In case of gas hobs, the minimum di-
stance from the downdraft edge to the
hob rear edge shall be of a least 60 mm.
3) Before making the hole, check that
there are no structural or other parts insi-
de the cabinet, where the appliance is to
be placed, which could hinder a proper
installation. Check that the overall di-
mensions of the Downdraft and its motor
are compatible with the cabinet so that
installation can be carried out properly.
4) Apply the glue on the lower side of the
frame (fig. 2).
5) Fit the Downdraft inside the cabinet by
inserting it from above, without removing
the glass and panel protections.
6) The appliance frame shall perfectly
adhere to the kitchen upper worktop.
7) Secure the hood inside the cabinet by
using the two brackets provided (fig. 3).
DHK9000
It shall be installed inside your house and
connected to the Downdraft mounted in
your kitchen by using one of the 5 outlets
available , as shown in fig. 10.
It can be fixed on the wall, or on the flo-
or either in vertical (dis. 12) or horizontal
(dis.13) position, having the fixing surfa-
ce as reference.
Fixing operations : once the position and
installation method have been chosen
, please insert the anti-vibration rubber
seals into the brackets supplied (Fig.
14C).
The rubber seals are to be positioned in
the sides that will touch the wall.
Place the brackets (fig . 14A) on the con-
trol unit , by matching the unit holes with
the brackets holes and then fix using the
screws supplied (fig. 14B).
36