Hama EWS-870 Bedienungsanleitung Seite 7

Note – Snooze function
• While the alarm is sounding, press the
SNOOZE/LIGHT button (8) to activate the
snooze function. The alarm symbol (3) begins to
flash on the display. The alarm is stopped for 5
minutes, after which it will sound again.
• The snooze function can be used over a
24-hour period.
Celsius/Fahrenheit
• Move the °C/°F slide switch (11) to the °C or °F
position to display the
temperature (6,7) in the respective unit.
6.4. Maximum and minimum temperature and
humidity values
• The base station automatically stores the
maximum and minimum outdoor/indoor
temperature values.
• Repeatedly press the MEM– button (14) to switch
between the current temperature, minimum
temperature (MIN) and maximum temperature
(MAX).
• The maximum and minimum values are displayed
for 5 seconds.
• Press and hold the MEM– button (14) to reset the
stored maximum and minimum values.
6.5. Frost warning
• If the outdoor temperature (6) is between -2°C
and ~ 3°C, the frost warning symbol
on the LCD and flashes continuously.
• The frost warning symbol
temperature rises above this range.
6.6. Backlight
Note – Backlight
• If you press the SNOOZE/LIGHT button (8), the
display will light up for approx. 5 seconds.
6.7. Low battery charge
As soon as the battery symbol
the display of the base station, the capacity of the
batteries in the measuring station is very low. Replace
the batteries immediately.
6
appears
disappears once the
appears on
Note – Replacing the batteries
• Note that the stations have to be
resynchronised each time after you change the
batteries in the measuring or base station.
• To do this, remove the batteries from the other
station and then reinsert them, or change them
as required.
6.8. Reset
• If displays/transmissions continually fail to appear
or are incorrect, use a pointed object (paper
clip, etc.) to press the RESET button (15) on the
base station and the RESET button (20) on the
measuring station to carry out a restart.
• The base station returns to the factory settings and
all stored information is lost.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
Make sure that water does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
9. Service and Support
Please contact Hama Product Consulting if you have
any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com