Chauvet Professional Maverick MK2 Wash Schnellanleitung Seite 57

Operation
IP Mode
The IP address of the Maverick MK2 Wash can be set manually, by the network, or to a preset static
address specific to each product. To set the IP Mode, follow the instructions below:
1. Navigate to the
2. Use <UP> or <DOWN> to select IP Mode, or touch the display where it says IP Mode.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from:
• Manual (set the IP address with the control panel)
• DHCP (the network sets the IP address)
• Static (a preset address specific to each product), or touch the display where it says the
desired mode
5. Press <ENTER>.
IP Address
In Manual IP Mode, the IP address must be assigned through the product menu. To set the IP address in
Manual IP Mode, do the following:
1. Navigate to the
2. Use <UP> or <DOWN> to select IP, or touch the display where it says IP.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Set the IP address (from 000.000.000.000 to 255.255.255.255) with one of the following methods:
• Through the touchscreen:
a. Touch the display where it shows the byte (set of three numbers) to be changed.
b. Use the number pad on the display to enter the desired number.
c. Repeat until the IP address is set as desired.
• With the buttons:
a. Use <LEFT> or <RIGHT> to select the byte (set of three numbers) to be changed).
b. Use <UP> or <DOWN> to increase or decrease the value.
c. Repeat until the IP address is set as desired.
5. Press <ENTER>.
Subnet Mask
In Manual IP Mode, the Subnet Mask must be assigned through the product menu. To set the Subnet Mask
in Manual IP Mode, do the following:
1. Navigate to the
2. Use <UP> or <DOWN> to select SubMask, or touch the display where it says SubMask.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Set the Subnet Mask (from 000.000.000.000 to 255.255.255.255) with one of the following methods:
• Through the touchscreen:
a. Touch the display where it shows the byte (set of three numbers) to be changed.
b. Use the number pad on the display to enter the desired number.
c. Repeat until the Subnet Mask is set as desired.
• With the buttons:
a. Use <LEFT> or <RIGHT> to select the byte (set of three numbers) to be changed).
b. Use <UP> or <DOWN> to increase or decrease the value.
c. Repeat until the Subnet Mask is set as desired.
5. Press <ENTER>.
In DHCP or Static IP Mode, the IP and SubMask menu settings have no effect on the
product.
Maverick MK2 Wash User Manual Rev. 10
Network Settings menu.
Network Settings menu.
Network Settings menu.
Page 42 of 275