System Information; Offset Mode - Chauvet Professional Maverick MK2 Wash Schnellanleitung

Operation

System Information

All information about the current status of the Maverick MK2 Wash is available through the product's Sys
Info menu. To view this information, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Sys Info, or touch the display where it says
Sys Info.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select from Fixture Information (shows firmware version, running
mode, starting address, etc.), Fan Information (shows speed of the head fans in rpm), Error
Information (shows any errors or No Error!), or Channel Information (shows the current value
of all signal input channels), or touch the display where it says the desired option.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to scroll through the information.

Offset Mode

The Offset mode provides fine adjustments for the home position of all the moving parts in the optical path
and the pan and tilt movements. This allows the moving parts to not show any border or to reduce the light
output when in their home position. To access this mode, follow the instructions below:
1. Starting from the Main Level screen, press and hold <MENU> until the passcode screen appears.
2. Enter the passcode 2323 using one of the following methods:
• Through the touchscreen: use the number pad on the screen to enter 2323.
• With the buttons:
a. Use <DOWN> to select the number to be changed.
b. Use <UP> to increase the value.
c. Repeat until 2323 has been entered.
3. Press <ENTER>.
4. This brings you into the Zero Adjust menu screen.
PAN
To adjust the starting point of the pan motor, follow the instructions below:
1. Use <UP> or <DOWN> to select PAN.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the starting value, from 000–255.
4. Press <ENTER>.
TILT
To adjust the starting point of the tilt motor, do the following:
1. Use <UP> or <DOWN> to select TILT.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the starting value, from 000–255.
4. Press <ENTER>.
ZOOM
To adjust the starting point of the zoom motor, follow the instructions below:
1. Use <UP> or <DOWN> to select ZOOM.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the starting value, from 000–255.
4. Press <ENTER>.
MAC Address
To adjust the fourth, fifth, or sixth digit of the MAC address, do the following:
1. Use <UP> or <DOWN> to select MAC4, MAC5, or MAC6.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to increase or decrease the value, from 000–255.
4. Press <ENTER>.
Maverick MK2 Wash User Manual Rev. 10
Home Screen shows on the display. Press <ENTER>.
Page 48 of 275