Remote Control Mode Operation; Rs 232 Control Mode Operation - Varian Turbo-V 70 Bedienungshandbuch

Remote Control Mode Operation

If remote signals are used to operate the controller, it
must be programmed for remote operation (see
paragraph "FRONT/REMOTE/232
when ready to start, the display shows:
R E A D Y F O R
S O F T S T A R T
If the Soft Start has been deselected the display shows:
P U M P R E A D Y
R E M O T E
With or wihout Soft
START/STOP and LOW
pushbuttons are inoperative,
NUMBER and PUMP CURRENT pushbuttons are
always active.
Selection")
R E M O T E
: U S E
S T A R T
Start mode selected
SPEED front panel
while the CYCLE

RS 232 Control Mode Operation

If the RS 232 option is installed and the controller has
been programmed for RS 232 operation, the controller
and may be driven by a computer and when ready to
operate, the display shows:
R E A D Y
S O F T
If the Soft Start has been deselected the display shows:
P U M P
R S 2 3 2
the With or wihout
START/STOP, LOW SPEED functions are under
computer control, while the CYCLE NUMBER and
PUMP CURRENT front panel pushbuttons are always
active.
885
TECHNICAL INFORMATION
F O R R S 2 3 2
S T A R T
R E A D Y : U S E
L I N E
Soft Start mode selected
87-900-868-01 (F)
the