HANSGROHE Focus E Montageanleitung Seite 21

Important! The fitting must be installed, flushed and
tested after the valid norms!
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation
valves; cold right - hot left.
5. 31700XXX/31704000/31720XXX:
Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
Rate of flow:
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
English
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15MPa.
If the continuous water heater causes any problems
or there is not enough flow of water, the EcoSmart®
(5a) located behind the aerator must be removed.
To adjust the hot water limiter on single lever
mixers, please see page 7.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
9
8 l/min 0,3 MPa 10
max. 1 MPa 11
12
0,1 - 0,5 MPa
1,6 MPa 13
max. 80°C
65°C
handle
capot sphérique
nut
cartridge cpl.
aerator
pull rod
fixing set
connection hose 3/8"
connection hose 470 mm
seal
chain for plug
adapter for cartridge
screw
31791000
96338000
96656000
96690000
92730000
13912000
96657000
96016000
97206000
96321000
97608000
97109000
98750000
97736000
5