Setting Up The Remote- Controlled Socket - Silvercrest 91210 Bedienungs- Und Sicherheitshinweise

Setting up
pushing away the battery compart-
ment cover
4
two batteries AAA. Make sure you
fit the battery the right way round
(polarity).
2. Press one of the ON / OFF buttons
or to test whether the remote
2 3
control works; if it does, the power
indicator light will come on
©
Setting up the remote-
controlled socket
1. Insert the remote-controlled socket
into an earthed household socket
and switch it on with the ON / OFF
switch . The LED operating status
5
display will come on.
6
2. Point the remote control at the remote-
controlled socket at a distance of
approx. 50 cm.
3. Press the LEARN button
remote-controlled socket for ap-
prox. 3 seconds and release it
again. The LED operating status dis-
play will flash for approx. 10
6
seconds. While it is flashing, press the
desired ON button of the channel
ON / OFF button
of the remote control. The LED op-
erating status display
shine permanently. You can now
switch a connected consumer on or
off using the remote control.
4. Repeat this procedure with the other
remote-controlled socket.
5. You can switch several remote-con-
trolled sockets on and off at the
same time using the ON / OFF but-
8 GB
downwards. Insert
.
1
of the
7
(A, B, C or D)
2
will now
6
ton of one channel. In addition,
2
you can programme six remote
controls one after the other and use
them for individual receivers. This
means you can switch one appliance
on and off from up to six different
places.
6. In this case, synchronise every remote-
controlled socket with the channel
of the remote control.
7. The coding of the remote control
will be maintained even when you
change the batteries.
8. If you disconnect the remote-con-
trolled socket from the power supply,
the codings will be permanently
stored.
9. In order to delete the codings again,
press the LEARN button
than 6 seconds until the LED oper-
ating status display
All codings will now be deleted.
10. Avoid interference: Make sure that
the distance between the various
remote-controlled sockets is ap-
prox. 50 cm.
11. Every remote-controlled socket also
has a manual ON / OFF switch
You can switch the remote-controlled
socket on and off without using the
remote control. The LED operating
status display
whether the remote-controlled sock-
et is in the ON / OFF mode.
longer
7
starts to flash.
6
5
will indicate
6
.