Replacing The Battery; Setting Up The Remote Controlled Socket - Silvercrest 322055 Bedienungs- Und Sicherheitshinweise

Replacing the battery

CAUTION! Danger of explo-
sion in the case of improper
battery replacement. Only re-
place with the same or equiva-
lent battery type.
1. Open the battery compartment
on the back of the remote control
by turning the battery compart-
ment cover 4 anti-clockwise with
the aid of a coin or a screwdriver,
then removing the lid (open).
2. Replace the button cell type CR
2032. Make sure you fit the
battery with the correct polarity
(+ = up).
3. Place the battery compartment
cover 4 back on and lock it in
place by turning it in a clock-
wise direction (close).
4. Press one of the ON / OFF
buttons 2 or 3 to test whether
32 GB
the remote control works; if it
does, the power indicator light
will come on 1 .
Setting up the remote
Q
controlled socket
(fig. B)
1. Plug the wireless socket into an
earthed mains socket. You now
have 30 seconds to complete
steps 2 and 3.
Note: Always plug in the wire-
less socket in the direction indi-
cated on the product label to
maintain the splash water protec-
tion (arrow must point up).
Protection against water spray
is only guaranteed when a
socket of the same protection
rating (classification IPX4) is
connected.