Setting Up; Preparing The Remote Control; Setting Up The Remote- Controlled Socket - Silvercrest 284705 Bedienungs- Und Sicherheitshinweise

Wear suitable protective gloves at
all times if such an event occurs.
In the event of a leakage of batter-
ies / rechargeable batteries, imme-
diately remove them from the
product to prevent damage.
Only use the same type of batteries /
rechargeable batteries. Do not mix
used and new batteries / recharge-
able batteries.
Remove batteries / rechargeable
batteries if the product will not be
used for a longer period.
Risk of damage of the product
Only use the specified type of bat-
tery / rechargeable battery!
Insert batteries / rechargeable bat-
teries according to polarity marks
(+) and (-) on the battery / recharge-
able battery and the product.
Clean the contacts on the bat-
tery / rechargeable battery and
in the battery compartment before
inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
©

Setting up

©
Preparing the remote
control (fig. A)
CAUTION! Danger of explosion in
the case of improper battery re-
placement. Only replace with the
same or equivalent battery type.
Introduction / Setting up
1. Open the battery compartment on
the back of the remote control by
turning the battery compartment
cover 4 anti-clockwise with the
aid of a coin or a screwdriver, then
removing the lid (open).
2. Insert the round cell battery type
CR 2032. Make sure you fit the
battery with the correct polarity
(+ = up).
3. Place the battery compartment
cover 4 back on and lock it in
place by turning it in a clockwise
direction (close).
4. Press one of the ON / OFF buttons
2 or 3 to test whether the remote
control works; if it does, the power
indicator light will come on 1 .
©
Setting up the remote-
controlled socket
1. Plug the remote-controlled socket
into an earthed household socket.
2. The LED operating status display
will now flash slowly for approx.
30 seconds after plugging in.
3. Aim the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
4. With the LED operating status dis-
play flashing, press the desired
5
ON button of the channel ON /
OFF button
2
the remote control. The LED operat-
ing status display
continuously. You can now use the
remote control to switch a con-
nected device on or off using.
5
(A, B, C or D) on
will now light
5
GB 9