Setting Up; Preparing The Remote Control; Setting Up The Remote-Controlled Socket - Silvercrest 284705 Bedienungs- Und Sicherheitshinweise

©

Setting up

©
Preparing the re-
mote control (fig. A)
CAUTION! Danger of explosion
in the case of improper battery
replacement. Only replace with
the same or equivalent battery
type.
1. Open the battery compartment
on the back of the remote control
by turning the battery compart-
ment cover 4 anti-clockwise
with the aid of a coin or a
screwdriver, then removing the
lid (open).
2. Insert the round cell battery
type CR 2032. Make sure you
fit the battery with the correct
polarity (+ = up).
3. Place the battery compartment
cover 4 back on and lock it in
place by turning it in a clock-
wise direction (close).
4. Press one of the ON / OFF
buttons 2 or 3 to test whether
the remote control works; if it
does, the power indicator light
will come on 1 .
©
Setting up the remote-
controlled socket
(fig. B)
1. Plug the wireless socket into an
earthed mains socket. You now
have 30 seconds to complete
steps 2 and 3.
Note: Always plug in the
wireless socket in the direction
indicated on the product label
to maintain the splash water pro-
tection (arrow must point up).
Protection against water spray
Setting up
GB 29