Replacing The Battery; Setting Up The Remote- Controlled Socket - Silvercrest 322055 Bedienungsanleitung

Replacing the battery

CAUTION! Danger of explosion
in the case of improper battery re-
placement. Only replace with the
same or equivalent battery type.
1. Open the battery compartment on
the back of the remote control by
turning the battery compartment
cover anti-clockwise with the
4
aid of a coin or a screwdriver, then
removing the lid (open).
2. Replace the button cell type CR
2032. Make sure you fit the battery
with the correct polarity (+ = up).
3. Place the battery compartment
cover back on and lock it in
4
place by turning it in a clockwise
direction (close).
4. Press one of the ON / OFF buttons
or to test whether the remote
2 3
control works; if it does, the power
indicator light will come on
S etting up the remote-
Q
controlled socket
1. Plug the remote-controlled socket
into an earthed household socket.
2. The LED operating status display
will now flash slowly for approx.
5
30 seconds after plugging in.
3. Aim the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
4. With the LED operating status dis-
play flashing, press the desired
5
ON button of the channel ON /OFF
10 GB/IE/NI
button
mote control. The LED operating
status display
continuously. You can now use the
remote control to switch a con-
nected device on or off using.
5. Repeat this process with the other
wireless sockets.
Note: You can use one channel
ON / OFF button
several remote-controlled sockets
at once. You can further train six
remote controls successively and
use these for a single receiver. This
means you can switch one appliance
on and off from up to six different
places. In this case, synchronise
every remote-controlled socket with
the channel of the remote control.
Note: The codes for the remote
control will also remain stored
when changing the batteries.
Note: The codes will remain
. permanently stored when discon-
1
necting the remote-controlled
socket from the power supply.
However, the remote control cannot
be used for at least 30 seconds af-
ter the connection is renewed, as
this can cause new encoding to
take place.
Note: Avoid interference: Ensure
the various remote-controlled sockets
are approx. 50 cm apart.
Note: The LED operating status dis-
play
trolled socket is in ON / OFF mode.
(A, B, C or D) on the re-
2
will now light
5
to switch
2
indicates if the remote-con-
5