Installation Of Outdoor Unit - Toshiba RAV-SM1603AT-E Installations-Handbuch

Digital Inverter
2. Serial installation of two or more units
300
or more
Serial installation at front and rear sides
Open the upper side and both right and left sides.
The height of obstacle at both front and rear sides
should be lower than the height of the outdoor
unit.
▼ Standard installation
1000
or more

Installation of Outdoor Unit

• Before installation, check strength and
horizontality of the base so that abnormal sound
does not generate.
• According to the following base diagram, fix the
base firmly with the anchor bolts.
(Anchor bolt, nut: M10 x 4 pairs)
Drain
nipple mounting hole
9-EN
300 1500 2000
or more or more or more
Drain hole
525
150
600
Drain hole
• As shown in the figure below, install the
foundation and vibration-proof rubbers to
directly support the bottom surface of the fixing
leg that is in contact with the bottom plate of the
outdoor unit.
* When installing the foundation for an outdoor
unit with downward piping, consider the piping
work.
300
or more
Fixing leg
Foundation
Foundation
200
or more
If only the end of the
fixing leg is
supported, it may be
deformed.
Foundation
Set the out margin of the anchor bolt to 15 mm or
less.
150
– 9 –
Outdoor Unit Installation Manual
GOOD
Absorb vibration
with vibration-
proof rubbers
GOOD
Bottom plate
of outdoor unit
Support the bottom surface of
the fixing leg in contact with
the bottom plate of the outdoor
unit.
NO GOOD
Do not support
the outdoor unit
only with the
fixing leg.
15 or less