Using The Menu System; Default State - Philips VARI LITE 400 series Handbuch

❋
VARI LITE - VL440 / VL770 / VL880 L

Using the Menu System

To enter the menu system, first press [ESC]. The functions displayed will be 1st level functions. Scroll
through the 1st level functions by pressing [Up] / [Down] arrows. Once the desired function appears in
the display, press [Enter]. You are now at the 2nd level. Once again, press the [Up] / [Down] arrows to
scroll through 2nd level functions. Press [Enter] to access 3rd level functions and so forth. When the
highest level for the function is reached, [Up] / [Down] arrows can be pressed to enter a value or select
a toggle activation such as On/Off. Press [Enter] to store the value or select an action.
For example:

Default State

The menu display's default state during normal operation is to display the DMX address. After 10
seconds of inactivity at the display, it will change to the default state.
After longer periods of inactivity, the menu display will switch to its off state. The default state for this
feature is 5 minutes, however, different time lengths can also be programmed.
To program a different time length for menu off feature:
Step 1. Press [ESC].
Step 2. Press [Up] / [Down] arrows until Config (Configuration) appears. Press [Enter].
Step 3. Press [Up] / [Down] arrows to access Display. Press [Enter].
Step 4. Press [Up] / [Down] arrows to select either 30 Sec (30 seconds), 5 Min (5 minutes), 10
Min (10 minutes), or ON (on indefinitely). Press [Enter] to set.
64
U
UMINAIRE
1st Level
Test
31 Octo be r 20 13
' M
SER S ANUAL
2nd Level
All Seq
3rd Level
RUN TEST
02 .9 687 .00 01 C