Dometic REFRIGERATION 9 serie Montageanleitung Seite 24

Installing the refrigerator-oven combination
6.9 Changing the door hinges (RMLT943x only)
To change the refrigerator door hinges, proceed as follows:
➤ Remove the control panel.
– RMLT9430: Unscrew the dials carefully and loosen the screws, fig. g,
page 8
– RMLT9431/9435: Open the refrigerator door and undo the screws under-
neath the control panel, fig. h, page 8
➤ Undo the hinge screw on the top door hinge and keep it in a safe place (fig. i,
page 8).
➤ Lift up the door and remove it (fig. j, page 8).
➤ Undo the two screws on the door lock and remove the door lock (fig. k,
page 9).
➤ Place the door lock on the other side again and tighten it with the two screws
(fig. l, page 9).
➤ Undo the hinge pin (fig. m, page 9) and position it on the other side (fig. n,
page 9).
➤ Turn the door by 180° (fig. o, page 9).
➤ Place the door on the hinge pin.
➤ Tighten the hinge screw at the top door hinge.
➤ Replace the control panel and screw it down tightly.
24
RMLT9xxx
EN